Arduino Nano V3 case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple printed case for the Arduino Nano V3. The bottom half has two rows for the bottom pins.
- Rating
- 4.6 / 5
- Likes
- 45
- Downloads
- 672
- Makes
- 8
- Views
- 3,037
- Reviews
- 5
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
A simple printed case for the Arduino Nano V3. The bottom half has two rows for the bottom pins. The top design allows access to the reset pin through the center hole and visibility for the four onboard LEDs. The two halves fit together with simple friction and are held together with the help of the natural ridged pattern from fused filament printing.
Print instructions
Category: Electronics Instructions
I've only been able to print with PLA on a Printrbot Simple with the sizes in this model. The bottoms and sides are thin enough that the infill percentage doesn't make much difference. It's a relatively tight fit for the three Nano boards I had available, so I'm not certain if shrinkage with ABS would be an issue.