30deg wallmount spoolholder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A spool holder that mounts to the wall at 30 degrees. This is designed to mate to the recess in my metal garage frame,…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 5
- Makes
- 0
- Views
- 144
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A spool holder that mounts to the wall at 30 degrees.
This is designed to mate to the recess in my metal garage frame, but could be readily remixed to work for a flat wall.
This differs from many other spool holders in that it is designed to use a 150mm M6 bolt axle (rather than 8mm) and MR106ZZ bearings. These smaller bearings allow a wider range of spools to fit onto the cones.
Print two cones, and put two bearings in each cone.
Use a fully-threaded 150mm M6 bolt, so you can run a nut all the way up it to bolt it securely to the spool holder.
Wall attachment is via 3 M4 screws.
Print Settings
Printer:
HE3D sky
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
20% or more for strength
Filament:
generic PLA, ABS or whatever
Notes:
Thick walls for strength.
Source design is available at https://cad.onshape.com/documents/af649b145a9943b25a010d86/w/0b8847cb97f73e4f1b4c3c95/e/96645f775fdb7b846bce6c06
NB that the 30 degree angle is about the maximum for this design; this results in a 60 degree overhang angle which is about the limit for many printers.
Some of the bracing also depends on the printer being able to handle 60degree overhangs.
Category: 3D Printer Accessories