1 / 5
TM22 Mag sleeve - Metal and Poly Mags — image 1
1 / 5

TM22 Mag sleeve - Metal and Poly Mags

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Modified to accommodate the metal mags as well as polymer. Contains solid and cut-out versions.

Rating
0 / 5
Likes
3
Downloads
28
Makes
0
Views
147
Reviews
0

Updated at source:

Model information

License
GNU Lesser General Public License

The original upload didnt work with metal mags.  this version has a slight modification to fit those mags as well as the Polymer 10rd mags. Contains solid and cut-out versions.

Copied from Original:

"Required Components: 

- 4x M3x16mm allen bolts 

- 1x M3x12mm allen bolt (you can use another 16mm one here, but it may protrude more than desired) 

- 5x M3 nuts 

 

Print Settings: 

0.1 mm layer height for detail, 0.4mm nozzle, fuzzy skin, supports required for overhangs at toe of magazine and spent casing sleeve. No supports needed for the base, but adding them won't hurt. 15% infill was fine. Use more to increase weight if desired. 

Print everything oriented right-side up.

 

Post Processing/Assembly: 

- Place the 10 Round magazine within the cavity 

- Add 6x spent casings in alternating direction (if you've selected the cutout option) - note these will be tight and won't sit properly until the other half "squishes" them into place 

- Place second half of magazine over the magazine/casings, and press firmly into place. 

- Secure with M3 nuts/bolts. Hand tighten to your preferences. 

- Add the base. This should fit quite tight and may require some ahem elbow grease (banging it on a table) to get it to seat into place. If you'd prefer easier install/removal, you can lightly sand the flared portion of the main magazine parts. Not using fuzzy skin will likely reduce the tightness of this fit, but I have not tested."