RFID Tag Holder for Inland V 2.0
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a revision of my previous tag holder. This attempts to fix any snagging that the old holder had.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 16
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
d_v_ermakov did a great job of creating an RFID tag holder for cardboard reels. I had previously remixed it so that it would fit Inland's cardboard reals - the hole spacing was different. (Inland is Microcenter's in-house brand). It worked fine, but a problem arose: occasionally I would get filament jams. The reel wouldn't turn, and my K2 Plus Combo would simply chew through the filament and fail. It took awhile for me to debug it. I had assumed some internal issue, but after awhile I found the issue: in the CFS, there's a low partition separating each reel compartment. The tag would occasionally catch on that low wall, causing the reel to lock up, and thus the jam.
I looked at just bevelling the edge of the holder, but it's so thin I didn't really think it would make a difference.
So I created this. The idea is to make sure that the edge of the holder is never parallel to the edge of the partition, AND the edges are bevelled. This should help the holder simply move to the side of the wall, allowing the reel to continue turning.
Note well: I just printed these and have not done extensive testing yet, though I intend to. However, I didn't want to delay release in case this would help others. If you use these, and especially if you've had similar jamming problems as I have, please let me know your experience with these tags. If they work, GREAT! If not, then let's look at them and figure it out together.
