1 / 12
Telepathic Gears Fidget - One Spinns the Other! — image 1
1 / 12

Telepathic Gears Fidget - One Spinns the Other!

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Very entertaining spinner using magnets. Who says gears need to touch each other?

Rating
0 / 5
Likes
14
Downloads
18
Makes
0
Views
724
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

Introduction

By using magnets and arranging them so that they both attract and repel one another you can make two gears interact without actually touching. As magnets quickly become weaker over distance its hard to apply this in any real world application, but in a fidget toy it works great! 

By spinning each other through thin air the gears have a very satisfying interaction. If you instead hold one of the gears in place and spin the other one it will move in a clicky-like motion.  

Parts to print and hardware

  • 14x 8x3mm cylinder (square should work as well) neodymium magnets, preferably N52 grade. 

  • Big gear

  • Small gear

  • Big gear lid

  • Small gear lid

  • 2x Rods

  • 2x Bridges (The body)

  • 4x small pieces of filament

Se (I) picture in assembly

Printing

  • Print as you are used to, this shouldn't be complicated.

  • 0.20 mm layer-height is recommended. 

  • Most materials work fine. I used PLA. 

  • Supports needed only for the "Bridge" parts. (Se (V) picture in assembly)

  • For print-orientation please see the provided 3mf file. 

Assembly 

I. Print all parts. Also prepare 14x 8x3mm cylinder magnets and cut 4 pieces of filament. 

II. Insert the magnets in the designated holes in the small and big gear. The magnets should be inserted with alternating poles: Once with the north pole facing outwards and once with the south pole facing outwards and so on. It is possible to arrange the magnets in other ways, but I found this one to give the best results. 

III. Screw on the lids of the small and big gears as much as possible. Also make sure that the teeth of the lid align with those of the gear. You will probably end up having a small gap between lid and gear. 

IV. If you want the gears to spin smoother, apply some sort of lubricant to the small rods. This is not necessary. 

V. Carefully remove the supports of the two "Bridge" parts. 

VI. Put the rods into one of the "Bridge" parts and align the small holes on the rod with those on the "Bridge". Then attach the two gears. 

VII. Put on the other "Bridge". Note that the "Bridge" parts have two different ends. The one with the longer neck is supposed to be over the big gear. 

VIII. Insert the pieces of filament entirely through the four small holes. 

IX. Cut the excess of the filament pieces as close as possible to the body of the spinner. 

X. Enjoy the result and feel free to ask if you wonder something! 

Thanks for printing! 

Tags