Charcoal filter for laser cut exhaust 100mm (parametric?)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Active charcoal filter 100mm
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 3
- Makes
- 0
- Views
- 30
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is an improvement to my Vevor laser cutter filter. The stock filter works well, but it lets out some unpleasant odors that can annoy my neighbor (i live in an apartment, and exhaust my big tube (no you wont make this joke uncle!) on the terrasse).
With this addition, I eliminated 99% of the residual smells—scientifically proven by my nose!
I used metal mesh (thin yet sturdy, like mosquito netting) for both end.
For the final output, I added kitchen exhaust filter mesh to prevent any charcoal particles from escaping the filter.
The activated charcoal I used comes in pellet form (about 400g of fine pellets), typically meant for aquarium water filtration.
You’ll need some strength to close both sides of the filter—this is normal as it should fit tightly.
Settings:
Infill: 15% honeycomb
Layer height: 0.28mm
Wall lines: 3
No supports, brim, or raft
The design is parametric—I based my first build in Fusion 360 using the initial sketch’s OUTSIDE DIAMETER. Some details may need adjustment to suit your needs.
I hope this will be useful to someone else ;-)
share a like, and gimmi my prusameters!
as usual, public licencing but made with fusion and maker's licence so you know what it means.
This is an addition to my other model :