Louqe Ghost R1 custom feet adapter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a spacer/adapter to use custom feets on this case. Needs to use a M3 screw.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 39
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial
This is a simple spacer that slots in the Ghost R1 feet holes.
It allows you to use custom feets as long as they use a M3 screw.
For reference, I used these from AliExpress

As for the screws, if you have extra ones that came with the case you can use them. I used M3x6 or M3x8 titanium screws from AliExpress too.
Not much advice on print settings as I'm no expert on these. It's fast but finicky, try to slow it down as much as possible to not yeet it from the plate. Tried 4 at a time and ended up with 3 usable.
Did mine without supports.
Installation is very easy (assuming you are using the inverted layout) :
watch any Uncle Roger's video related to cooking rice
remove the side panel (optional but makes it easier)
put the case on the side so you can access the bottom
plop the original rubbers off
put your M3 screw into the spacer
using one or two fingers, put spacer+screw in the feet hole from inside the case, and keep pressure on the screw (if you're feeling lucky or skillful enough, do it with the computer still powered on)
using the fingers on your other hand, screw the feet on, finger tight will do it
repeat 3 other times
put the case back on it's feets and close it.
