Parametric nitrile glove box holder for pegboard (Sy Peglock)

This model lets you create custom pegboard glove box holders for the Sy Peglock system.  I wanted something that was parametric and used minimal filament. 

Procedure:

1. Load the model into Fusion and select Modify → Change Parameters.  Change boxHeight and boxWidth for your box size (see image example) and click OK.  The model is designed so that the box is oriented horizontally and the gloves are dispensed laterally.  There is a counterexample in the photo where a Kleenex box is dispensing vertically, but that's because the height and width happen to be equal.

2. Expand the Browser hierarchy in Fusion, right-click on the "left side" component, and then Save as Mesh to bring the objects into the slicer (I'll use PrusaSlicer in the remaining steps).

3. In the slicer, right-click on the object and Split → To objects.  You can optionally rename the sides to keep them organized.

4. Change the slicer supports option to "For support enforcers only".  For both left and right objects, right-click on the object, and then "Add support enforcer → box".  Create a support enforcer box for snug supports that overlaps with the peglock area.  I use a box size of 9x47x25 mm (see image example).

5. Print with the large hexagons facing down on the plate.

I printed these in both PLA and PETG at 15% infill, and either is fine.  Personally, PLA is easier for me to print.