1 / 3
VW Passat B3 (35i) Outer Door Handle Actuator Spacer / Nakładka popychacza klamki drzwi — image 1
1 / 3

VW Passat B3 (35i) Outer Door Handle Actuator Spacer / Nakładka popychacza klamki drzwi

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

4mm spacer for VW Passat B3 door handle pin. Reduces distance to the actuator for faster, easier door opening.

Rating
0 / 5
Likes
3
Downloads
14
Makes
0
Views
94
Reviews
0

Updated at source:

Model information

Category
Automotive
License
Creative Commons — Attribution — Noncommercial — NoDerivatives

Custom-designed 4mm spacer cap for the door handle actuating pin in the Volkswagen Passat B3 (35i).

Over time, wear in the factory mechanism increases the gap between the handle and the release lever, making the door hard to open. This push-on spacer reduces that distance by 4 mm, eliminating free play and allowing the outer door handle to trigger the mechanism effortlessly and immediately.

  • Function: Reduces distance to the actuator pin, eliminating play for smooth and instant door opening.

  • Important: If you are using an aftermarket / non-OEM door handle instead of the original, scale up the width of the model by 2% in your slicer for a proper fit.

  • Installation: Simple press-fit directly onto the factory pin.

  • Recommended Print Settings: PETG or ASA/ABS (for heat resistance inside the door panel), 0.2 mm layer height, 100% infill.

Dedykowana nakładka dystansowa (4 mm) na bolec popychacza klamki w Volkswagenie Passacie B3 (35i).

Z biegiem lat wyrobiony mechanizm klamki tworzy zbyt dużą odległość do dźwigni zamka, przez co drzwi otwierają się z ciężkim oporem. Nakładka skraca ten dystans o 4 mm, kasując jałowy luz i sprawiając, że klamka reaguje natychmiastowo i bez wysiłku.

  • Działanie: Skraca odległość do bolca popychacza, kasując luz i zapewniając szybkie oraz łatwe otwieranie drzwi.

  • Ważna wskazówka: Jeżeli posiadasz klamkę w zamienniku (nieoryginalną), zwiększ szerokość modelu o 2% w slicerze przed drukiem, aby zapewnić idealne dopasowanie.

  • Montaż: Na wcisk bezpośrednio na fabryczny bolec.

  • Zalecenia dotyczące druku: PETG lub ASA/ABS (odporność na wysokie temperatury wewnątrz drzwi latem), warstwa 0.2 mm, wypełnienie 100%.