Regal Frog King Sits His Throne

• These parameters are for an outdoor statue using iSANMATE ASA Filament 1.75mm Marble using a 4.0mm nozzle.

• INFILL: Because this guy is going to be outside, I set my infill at 50% Tri-hexagon. 

  Print Settings

  • Layer Height: 0.16 mm

  • Initial Layer Height: 0.20 mm

  • Line Width: 0.42 mm (for a 0.4 mm nozzle)

  Walls & Shell

  • Wall Count: 3

  • Wall Line Width: 0.42 mm

  • Top Layers: 5

  Material (ASA)

  • Nozzle Temp: 255–260°C

  • Bed Temp: 100–105°C

  • Chamber Temp: If available, 45–55°C

  • Fan Speed: 0% (ASA hates cooling — only use 10–15% for tiny overhangs)

  Speed

  • Print Speed: 40–50 mm/s

  • Outer Wall Speed: 100 mm/s

  • Inner Wall Speed: 150 mm/s

  • Initial Layer Speed: 20 mm/s

  Supports

  • Support Style: Tree

  • Support Density: 15% - 30%

  • Support Overhang Angle: 45°

  • Support Z‑Distance: 0.18mm

  • Note: The crown on my frog is missing the points as they broke off when removing the supports. I did re-mesh them in the final file version, so hopefully it won't be as much of a problem.

  Build Plate Adhesion

  • Brim: 8–12 mm ASA warps — (I did not use a brim and I didn't have any problems)

Hope you like this garden frog as much as I do.