Case for Philips Sonicare 4100
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Case for the electric toothbrush Philips Sonicare 4100
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 3
- Makes
- 0
- Views
- 40
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution — Noncommercial
A case for the Philips Sonicare 4100 electric toothbrush. The case is sliced with Prusa slicer using Paint-on supports with Automatic painting and Supports: For support enforcers only. The cover is printed upside down and doesn't require any supports. The sample model was printed with 5% infill to keep the weight to a minimum. The material in the sample was PLA.
One should be able to wiggle the charger into its slot though it might take some effort, the cable goes in first.
In use, the charger would be permanently inside the case as the brush could be charged without taking it off and only when actually travelling, the cable would be tugged in from the end, so that the cover could be slid over the case. When the cover is slid open you need to slightly lift the round edge to open the lock that keeps the cover shut.
There is stopper when sliding the toothbrush inside the case so that you need to rotate the brush slightly and rotate back when pushing in. This to avoid the brush falling out when opening the sliding cover.
One could also probably use a USB-A female to USB-C female adapter so the cable could permanently stay inside the case and normal USB-C charges could be used.