Fractal Design Ridge Graphics Card Fan high airflow mod
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The side panels are highly restrictive, this mod involves cutting out most of the GPU grating.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 1
- Makes
- 0
- Views
- 142
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution
I printed these in PETG-HF white.
This requires cutting out most of the GPU intake side fan grating, see photos below for measurements. The two holes are symmetrical and are designed around running 140mm fans mounted high using the bottom 120mm fan holes and only retained through pressure on top (I’ve done significant modifications to my case.
The dimensions of the top and bottom can be adjusted to fit your fans, if you’re using standard 120mm or 140mm fans, you might just need to tune the top and bottom openings to look clean.
After removing the grating, I had ~10C reduced GPU temperatures. After adding these grates, I saw no change in GPU temperatures. These grates aren’t heating up at all, even with 400-600W of energy being exhausted into them (I run a deshrouded RTX 4090 with 140mm fans exhausting through the grates) which is a good indication that they’re not restricting any airflow.
Depending on your GPU, if you’re using the factory shroud, it would be fairly easy to build in ducting to your GPU fans into these grates, whether directly molded into this part or rails that the ducting slides into that attach to the side panel.