Mojoh Ryzer Stance Mod

Modified leg angle blocks for the Mojoh Ryzer system that increases the width of the stance. Uses all of the original plastic screws. Effectively a drop in replacement.

The trickiest part of the replacement is needing some sort of clamp to hold the spring loaded anchor wire when assembling the block. A pair of small, very carefully adjusted, vice grips worked well for me. Don't clamp the wire too hard.

The increased angle could cause more strain on the blocks, so I would bias toward heavier duty print settings. I just used the default for my initial install (TBD on durability). The large fillet is tricky to print without support material. I kept it in the design so it would stay compatible with another accessory I have for the Ryzer.

One thing that might be good is adding some sort of cushion/rubber material where the legs make contact with the blocks when folded. You can see the original has some rubber pads for this.

Here is the model:

https://cad.onshape.com/documents/70bd6da7b3638bdf760df048/w/021277b9dc389fc77f9c048a/e/5cf96d672688028608d1c532?renderMode=0&uiState=6a8c89e9569b9402d00210cd