Slide and snap protective cover for Henson AL 13 Safety razor
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Minimalist slide-on with a nice 'click' for retention. blade is protected from any contact with the sides.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 4
- Makes
- 0
- Views
- 18
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution — Noncommercial
I lengthened this version a bit to help protect the razor and make it easier to remove the cover. (Mine was printed on Tevo Tornado with no changes to settings other than using a brim and it fits great.)
Text below is from Melted Pellets original description. (Thank you for a great minimalistic design!)
Original Description:
There were a couple minimal holders out there for the AL-13, but they had the following issues IMHO:
contact with blade: the blades were not protected from the sides. Sure, it's plastic … but the point is to be “razor sharp”, lets not rub it on anything. See the corners - the cover ONLY contacts the frame, not the blade.
lacking positive retention - relying purely on friction means it relies on the authors exact tolerance. With a positive lock against the handle, even if your printer is not that calibrated this should be able to securely attach.
ventilation: this is a minimal cover - it should allow as quick of drying as possible. The others had a closed end, sat flat on top of the head, etc. This is open on both ends (but fully guarded), and sits a mm off the top to minimize water retained.
On my XL, printing calibrated ASA (~0.6% shrink calibration) I have about 0.2mm of (intentional) interference against the frame on the corners. I've sized the hole for the handle small by about 0.5mm to allow you to take an exacto knife to it (shell is only 1.8mm thick) if it's too tight - I expected to need to shave it a bit on my print w/ a 0.6 nozzle, but didn't bother as it fits well as-is.
has a small ‘nub’ on the top to aid sliding it off. it slides off fine just grabbing the sides, but since it's a razor it seemed worth adding something more positive.