Arduino filastruder filiment guide with servo mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
changed it so that a mini servo such as tower pro (SG90) can fit, small bit of filling needs doing as about 0.5 mm to…
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 23
- Makes
- 0
- Views
- 222
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution
changed it so that a mini servo such as tower pro (SG90) can fit, small bit of filling needs doing as about 0.5 mm to wide, also i used an Arduino sketch with this which operates this at slow speed.
Remember to download the VarSpeedServo.h library. https://github.com/netlabtoolkit/VarSpeedServo
Connections are.
5v
Ground
Pin 9 for the signal (Normally the orange wire)
The Arduino sketch.... will not work unless the Library from the above link is added.
// speed controlled Servo Sweep
// see: http://arduino.cc/forum/index.php/topic,61586.0.html
//
// Michael Margolis 4 August 2011
// edited by http://www.bajdi.com
include
VarSpeedServo MyServo; // servo objects
int servoSpeeds = 1; // sweep speed, 1 is slowest, 255 fastest)
int servoMinPosition = 0; // the minumum servo angle
int servoMaxPosition = 100; // the maximum servo angle
void setup()
{
MyServo.attach(9);
MyServo.slowmove(servoMinPosition,servoSpeeds) ; // start sweeping from min position
}
void loop()
{
// sweep the servos
if( MyServo.read() == servoMinPosition)
{
MyServo.slowmove(servoMaxPosition,servoSpeeds) ;
}
else if( MyServo.read() == servoMaxPosition)
{
MyServo.slowmove(servoMinPosition,servoSpeeds) ;
}
}
Category: 3D Printing
