1 / 2
Kia - Hyundai [Inverter] Coolant Reservoir Cap SST — image 1
1 / 2

Kia - Hyundai [Inverter] Coolant Reservoir Cap SST

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Fits many Kia/Hyundai models from about 2020 on that use part 25330-L1000. This is a SST (special service tool).

Rating
0 / 5
Likes
2
Downloads
16
Makes
0
Views
48
Reviews
0

Updated at source:

Model information

Category
Automotive
License
GNU General Public License v3.0

Print in place, it is technically 2 parts, but I have a small breakable bridge joining them as one stl. From what I can tell the original cap uses something like a 14x3mm o-ring (I suppose you could borrow the one off the oem cap). I did not have that on hand, so the second "undersized o-ring" stl works with a 9/16 x 3/32" (14.28x2.38) o-ring.

Mirror part for the left-hand thread inverter coolant cap.

This is very similar to what a shop uses to perform a pressurized drain procedure for the engine coolant (or as required by the dealership procedure for the inverter coolant (cap part# 25330-P4000), which is left hand thread).

This tool helps purge/drain coolant that would otherwise still be pooled in the heater core, oil cooler, and exhaust heat exchanger (which is well known to break down coolant, and potentially corrode and leak into the exhaust on these vehicles)

Center of cap is 1/4" NPT to take a standard compressed air fitting.

Note: You will need a pressure regulator

The engine coolant system operates below 16 PSI (what the oem cap/system is rated for), so obviously use a lower pressure than this.

For the special low conductivity blue inverter coolant, the service manual states a pressure of 2 bar or 19 PSI.

Once complete, the procedure is to pull a vacuum and refill using a vacuum refill kit (~$50 on amazon).