1 / 3
O.S. Bomba: Accessory Pack 1 (Power wing, Mini Mag & Short Barrel) — image 1
1 / 3

O.S. Bomba: Accessory Pack 1 (Power wing, Mini Mag & Short Barrel)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A Power Wing, Mini Mag and Short barrel for your O.S. Bomba toy

Rating
0 / 5
Likes
5
Downloads
28
Makes
1
Views
123
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

3 starter accessories to enhance your O.S. Bomba marble launcher!

Power wing: 
Plug it into the hold parts of your Bomba. By increasing the amount of force it takes to flex the hold parts, it will increase the power of your marble yeeting!

Mini Mag:
Increases your Bomba's inbuilt ammo capacity by approximately 2!

Mini Barrel:
Theoretically it should help with accuracy. Makes your Bomba Look cooler.
Requires "BombaBarrelFeet" & "BombaBarrelHolder" parts to attach it to your Bomba. (Alternatively, it's also compatible with the Super B-Daman Over Shell parts!)



Print Instructions:
there are two .3MF's included in case you are feeling lazy.

  • One .3mf for Bambu studio + p1p printer + PETG,

  • One .3mf for Snapmaker Orca + Snapmaker U1 printer + PETG

Else, you should probably use the STL files and manually configure the settings.

  • Enable supports (normal, not tree)

  • STL's should already be in optimal orientation



Assembly Instructions: 


For a preassembled Bomba, remove the Head Key and Upper Head Cap before proceeding

  1. First, you'll wanna install your Power Wing. Plug the two round pegs into the round holes of the "hold parts". This must be done before the magazine.

  2. Slide Mini Mag into railing that is located at the back of the Bomba’s head cavity. You can now reinstall the Upper head cap + Head key.

  3. Install the Mini Barrel. Assuming that you don't have an “Overshell Armor" for your Bomba, you'll wanna use the "BombaBarrelFeet" + "BombaBarrelHolder". First remove standard Bomba Feet, you'll need to replace them with the "BombaBarrelFeet". Plug the Mini Barrel's bottom peg into attachment hole of the "BombaBarrelFeet". Lastly attach a "BombaBarrelHolder" to the Hand and Mini Barrel on both sides. 




ALT PARTS + STP Notes:
If the Barrel Holders that attach to the hands + barrel are too loose, you can try the "(Tight)" version to see if it fits better.

If the Power Wing is too tight/won't fit the Hold Part's Holes, you can try the "(Loose)" version to see if that fits better.

STP Parts are not oriented in optimal orientation for printing. STP Parts were exported from Rhino3d and might have some errors. Hopefully it's easier to modify than STL files!

Tags