Baby Ape Pro v2 Feet / Motor Bumpers for 1204 Motors
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Motor bumpers / feet for the Baby Ape Pro V2, after replacing the small original motors with RCinPower 1204 motors.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 2
- Makes
- 0
- Views
- 19
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I replaced the low-quality, over sensitive stock motors in the Baby Ape Pro V2 with Rcinpower 1204 / 5000 kv motors. So I needed new feet / bumpers that fit with the new motors.
To mount the motors, I had to enlarge the screw holes in the arms with a 2mm drill bit. The new screws have a head diameter of 4mm.
When attaching the bumper, you have to slide it on at an angle and make sure that the tips of the arms are pushed all the way in. Then flip the bumper up toward the arm until the holes snap into place on the screws. No additional fastening required.
Printed in: Sunlu TPU 95A Red and Geeetech TPU 95A Neon Yellow.
This design is a remix of the bumpers made by Engineer Errant. Thanx for the original!