Freemax Mesh Pro guard and tip combo
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
There are a few options already but non combined. I dropped mine and broke the tip but I've always glued the separate…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 19
- Makes
- 0
- Views
- 125
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution
There are a few options already but non combined. I dropped mine and broke the tip but I've always glued the separate parts together as held in place better I found. Today I decided to design a combination of both. I also like a wider mouthpiece so I think in did up as well. I found that this new setup is super good fit even without the o-ring but I did put a place for the O-ring to be installed. hope someone else enjoys my design. I Did use suports but its a small enough print that it completes in about an hour. Print out of PETG for better strength but print however you see fit. Next one I print I'll stop part way so I can have TPU on the tip for strength if dropped and rest in my favorite translucent blue.
NOTE: The one in the picture above is my prototype so its not super clean. Ive adjusted since that some areas to make them thicker and stronger as well as changed the fillet to look and feel better.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
Yes
Resolution:
200
Infill:
30
Filament: Eryone PETG Transparent Blue
Category: Other