Pikachu Head Keychain — 30 mm Chibi Charm

A Pikachu head you can print tonight and hang on your keys tomorrow.

A chibi Pikachu head keychain — one solid piece with the hanging loop modelled into the top, so

there is nothing to glue and nothing to assemble. The face, cheeks and ear tips are cut into the

geometry rather than painted on, so they still read at keychain size and after a coat of paint. The

file is already at keychain scale: 33.4 × 26.3 × 29.6 mm, print it at 100 % and the loop comes out

right.

The photo is a real print — shot from behind, which is the view that shows the loop best. The other

images are renders of the same file, so you can see the face before you slice.

Why you will like it

- One piece, no assembly — the loop is part of the print. Add a split ring and it is done.

- The loop hole is 4.6 mm — measured in the file, at 100 %. A standard 20 × 1.2 mm split ring goes

straight through with room to spare — no drilling, no rescaling, no fused loop.

- Flat bottom — the head is cut off cleanly under the jaw and sits on 129 mm² of plate — the

largest footprint in this series, so it is the easy one to start with.

- Watertight and slicer-safe — a single closed solid, zero open edges, 179 934 triangles. No repair

step, no manifold warnings.

- Looks good in any colour — character colours if you have an AMS, or raw grey PLA like in the

photo. The recessed face takes a wash beautifully: brush a dark colour over the whole head and wipe

the high spots.