Hypercube Evolution Mods

Update 04/13/2020

Added STLs for Fan Duct. There are 3 designs to choose from and I've included all 3.

While building my own Hypercube, I chose parts I had on hand for the build and had to create/modify designs. I have listed them below:

• CR-10 Stock bed: Requires a different 15mm bed bracket with M4 holes and room for thumb screw
• 18mm LCJ18A3 Capactive ABL Sensor: Requires a mounting bracket located in a place which doesn't interfere with overall axes movement
• 16mm OD Wiring loom: Requires mounting bracket to secure it to the frame
• Z Nut Bracket: My hypercube required additional slot length on the nut bracket to correctly position the travel nut.

Design changes due to hardware mounting decisions:

• RAMPS 1.4 - Decided to mount the board to the frame instead of an acrylic sheet like Scott did on his printer. This required me to design a mounting bracket with 50mm fan shroud to cool the DRV8825 step sticks.
• Bed heater MOSFET: Designed a simple frame mount
• Bowden Mount: Decided to mount to the Right Rear Top corner, so had to design a new mounting bracket (Pic shows old version. Newer STL uploaded)
• Power Supply: Decided to mount to the frame instead of an acrylic sheet, so had to design a mounting bracket similar to the one created by Tech2C for his 2020 build.
• 12864 LCD: The LCD cannot be mounted to the bottom front of the frame using the existing FGSC mount as it interferes with the bed Z travel. Designed a new 20 deg. mount (It's mounted to the top rear of the frame in the picture, but can be mounted to the bottom front and will clear the bed)
• Spool Holder Rod Clamp: Didn't like Tech2C's version where the M8 threaded rod is clamped with screws so designed a more robust version that mounts to the frame. Threaded rod is clamped with 2 M8 nuts, one on either side of the rod holder - The nut facing the frame sits in a recessed hole

Changes to the original X Carriage:

• Added 2 M3 mounting points in the rear between the belt clamps (Needs threaded insert)

Changes to Original Hotend Mount:

• Removed 12mm Sensor cutout

Z-Probe Offsets to program in Marlin:

X: 0

Y: 75

Z: 0

Print Settings

Printer Brand:

Creality

Printer: 

CR-10S

Rafts:

No

Supports: 

Yes

Resolution:

0.2

Infill: 

50%+

Filament: Hatchbox PETG

Category: 3D Printer Parts