Nikon P1100 camera ARCA / Tripod /Cotton Carrier mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a brace to hold the P1100 firmly to a long Arca (or 1/4-20) tripod mount for better stability.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 21
- Makes
- 0
- Views
- 70
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The P1100 and its predecessors are compact bridge cameras with extremely long zoom lenses. Because of this the single 1/4-20 camera mount doesn't allow the camera to be balanced on a tripod (as I found, this is pretty critical when the lens is zoomed out to 3000mm!)
The part here was printed in ASA, (if you do this, make sure to correct for shrinkage ~0.5%) otherwise PLA and PET-G will work as is. The part fits tight onto a 150 mm Arca plate (https://a.co/d/04gSf9Aa) with a single screw.
Remove the 7 pads in the forward section of the plate for a tight fit to the printed part and attach with a flat head 1/4-20 screw ~ 10 MM / 7/16" max long (I had to cut a 1" screw down). the plate attaches at the opposite end with a standard D screw (or equivalent)
I my case I wanted to also attach a CCS (Cotton Carrier System) plate. This can be done with the use of the "nut plate" this plate is forced into the recess in the bottom of the Arca plate at the camera end then a 15/16" long hex head bolt (this necessitates opening up (use a 1/4" drill) the rear slot of the Arca plate to accept the screw in its center.)