1 / 1
Desk Clip Cup Holder for Hot Drinks (Anti-Spill Desk Clamp) — image 1

Desk Clip Cup Holder for Hot Drinks (Anti-Spill Desk Clamp)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

The image is for illustration only

Rating
0 / 5
Likes
27
Downloads
36
Makes
0
Views
394
Reviews
0

Updated at source:

Model information

Category
Other Ideas
License
Open Community License v1.1

Keep your desk clutter-free and safe from accidental spills! This is a robust, 3D-printed desk-clamp cup holder specially designed for standard paper/cardboard coffee cups (8oz to 12oz, approx. 75mm mid-diameter).

Unlike other designs, this holder uses a vertical spring-clamp mechanism. The circular base mounts vertically over the edge of the desk, providing high clamping force and maximum stability without wobbling or slipping, while the intersecting horizontal ring securely holds your beverage.

The junction between the two main cylinders has been structurally reinforced with heavy fillets to distribute the weight of a full cup and prevent layer shear or snapping.

📦 Available Sizes & Models:
To ensure a perfect fit for any workspace, I have created 15 different models, covering desk thicknesses from 5mm up to 20mm (in 1mm increments).

💡 Pro-Tip for Maximum Stability:
For the best and tightest grip, it is highly recommended to choose a model that is 1mm SMALLER than your actual desk thickness. For example: If your desk is exactly 20mm thick, download and print the 19mm version. The natural elasticity of the 3D-printed plastic will act as a powerful spring, clamping firmly onto your desk and preventing any slipping.

Features:

  • Perfect Fit: Ideal for standard disposable hot drink cups (stops at ~2/3 of the cup's height for maximum stability).

  • High Grip: Engineered to create a strong spring-loaded tension on the desk edge.

  • Heavy Duty: Reinforced joint structure to withstand daily use.


Print Settings (Recommended):

To ensure the clamp behaves like a strong spring and doesn't snap under load, please use the following slicer settings:

  • Orientation: Print it lying flat on its side (so the layers run continuously along the 'C' clamp loop for maximum tensile strength).

  • Material: PETG or ABS/ASA are highly recommended for their elasticity and heat resistance near hot coffee. PLA can work but may lose tension over time.

  • Wall Lines / Perimeters: 4 to 5 walls (Crucial! Structural strength comes from the walls, not the infill).

  • Infill: 25% - 30% (Gyroid or Grid).

  • Supports: No supports needed if oriented correctly on its side!


Design Tip for Users: After printing, you can stick a small piece of rubber or foam tape inside the clamp jaws to increase friction and protect delicate desk surfaces.