Little Ghost — Chunky Halloween Figure

A round little ghost with its arms out, printed in one piece.

No thin walls, no vase mode, nothing to glue. It is a solid figure that sits flat on a shelf, and

at 60 % scale it fits in a closed hand — 60.0 × 54.3 × 54.7 mm, about 33 g of PLA.

The photos are a real print of this file at 60 % scale, orange PLA, unpainted.

What is measured, not guessed

- Solid all the way through — 314 cm³ of mesh volume in the file, 0.6 % trapped air. No hidden

cavity, no shell that collapses when you drop it.

- Watertight — zero open edges, zero non-manifold edges, one connected solid, 199 974 triangles.

Nothing to repair before slicing.

- Flat base 445 mm² at 60 %. That is the smallest footprint of the eight in this series, which is

why the brim note below matters.

- Face is cut in, not painted on — two eyes and an open mouth, recessed deep enough to still read

after a coat of paint.