Witch Cat — Cat in a Pointy Hat

A sitting cat wearing a witch hat two sizes too big, printed as one piece.

The ears poke through the brim, the hat tip flops over, and the whole thing sits flat without a

stand. At 60 % scale it is 52.9 × 49.5 × 60.0 mm and about 24 g of PLA — the tallest and one of the

lightest of the eight.

The photos are a real print of this file at 60 % scale, orange PLA, unpainted.

What is measured, not guessed

- Watertight — zero open edges, zero non-manifold edges, one connected solid, 199 980 triangles.

- Biggest footprint but one — 1031 mm² at 60 %. It is the most stable figure in the set despite

being the tallest, because the hat brim is not what it stands on: the tail and haunches are.

- Face cut deep — eyes, muzzle and whiskers are recessed, not surface texture. They survive paint.

- 25.2 % of the surface past 45°, the highest in the set. Almost all of it is the underside of the

hat brim, and almost all of it is a gentle cone, not a ceiling.