1 / 3
Harman Kardon CEN TS20/30 Center Speaker Wall Mount — image 1
1 / 3

Harman Kardon CEN TS20/30 Center Speaker Wall Mount

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Wall bracket for the Harman Kardon CEN TS20/30 center speaker (HKTS 20/30). Two wall screws, no supports, STEP included.

Rating
0 / 5
Likes
0
Downloads
4
Makes
0
Views
37
Reviews
0

Updated at source:

Model information

Category
Living Room
License
Creative Commons — Attribution — Share Alike

A wall mount for the Harman Kardon CEN TS20/30 center speaker, the center channel from the HKTS 20 and HKTS 30 5.1 systems. I couldn't find a bracket for it, so I made one.

I modeled it last weekend, and it's currently mounted to my wall with the speaker on top. Turned out much sturdier than expected.

Designed in Shapr3D. I don't plan to change it, so the STEP is there for you to make it your own.

How it works

The mount screws to the wall, and the speaker sits on it. It's stable there on its own, but speakers vibrate, so I also screwed the speaker to the mount using the screw holes on the bottom of the speaker. Double-sided tape would probably do the job too. A notch in the mount lets the speaker cable exit at the back, hidden behind the bracket.

Size

100mm wide, 54mm deep, 50mm tall. The base is 10mm thick, both underneath the speaker and proud from the wall.

The actual speaker is 80mm x 44mm, so I modeled it around that as the baseplate and added 10mm in the back for both extra margin from the wall and somewhere to put the cable channel.

Printing

No supports. What I used:

  • ABS, 0.6 mm nozzle, 0.3 mm layers

  • 2 walls with alternate extra wall enabled, 13% infill

I'm pretty sure PETG and PLA both would be fine too.

Mounting

  • Bracket to Wall: two M5 screws. Bracket is 10mm thick, so you'll need longer than that. My wall plasterboard is 13mm thick, and I used wall plugs with M5x30mm which is fine even though 7mm is a bit on the low end of margin. M5x40mm would probably be better.

  • Speaker to Bracket: two screws around 2.5 mm in diameter and roughly 16 mm long. 10 mm goes through the mount and about 6 mm into the speaker. I used whatever I had in the drawer. You could probably use double-sided tape.

The speaker sits well even without attaching it to the bracket, but I wouldn't trust it to stay in place for years on its own.

Tags