1 / 5
SV06 Plus Z Bracket with V-slot Brace and M4 nut clamp to Z frame remix — image 1
1 / 5

SV06 Plus Z Bracket with V-slot Brace and M4 nut clamp to Z frame remix

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Fixing to the Z frame with M4 nuts and V-Slot for better alignment and stability

Rating
0 / 5
Likes
2
Downloads
8
Makes
0
Views
39
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

The SV06 Plus is a beast its very wide and tall and thus its lacking real support for remaining square so making a few changes to the Z motor mounts was a no brainer , while i really liked the work that SirKildon did merging models but i found the nut certs in particular a bit of a problem as even when put in with perfect alignment they lack the holding force to really clamp the Z motor bracket in place as they just tend to pull leaving very little holding the bracket , as there is quite a bit of leverage from the top of the Z frame i wanted to ensure that it could be done up tight and hold the bracket firmly , so i initially remixed the model for the addition of the M4 Nuts for stronger clamping force but then realized there were a couple of recessed bolt holes without the little no support trick for printing so fixed that as well as a bit of a tidy up on some of the missing champers  around the holes .

A have also added a V-slot bracket that takes a couple of M4 nuts and lines up with the holes for the Z Stepper brackets , makes it easy to install , make sure your M4 bolts are not too long as that will push up on the bottom of the Vslot and distort the squareness of the bracket , i could not find M4 bolts the exact length i needed so took some longer ones and grinded them down a little so they grab the nut in the vslot but dont hit the bottom of the vslot, they need to be around 8-9mm long .

I did this for myself really taking the brackets to the next level, but sharing for anyone else looking for this mod, give us a like or post a build , i spend a lot of time fixing these models so be good to have some feedback.

Printing well .. up to you .. I used ..
4 parameters , gyroid infill at 35% printed in PETG Carbon fibre 

enjoy .

Tags