1 / 6
Beawhistle — beaver whistle, loud twin-chamber, one piece, no supports — image 1
1 / 6

Beawhistle — beaver whistle, loud twin-chamber, one piece, no supports

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A beaver that is a loud twin-chamber whistle: blow the stick, sound from its back. One piece, no supports.

Rating
0 / 5
Likes
0
Downloads
7
Makes
0
Views
26
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

Beawhistle

A beaver standing upright on its flat tail, face turned to the sky, a chewed stick clenched in its teeth — and a loud pealess whistle. Blow into the top of the stick; the sound comes out of two slots between its shoulder blades. One piece, print-in-place, no supports, no glue and no hardware.

Hear it

The clip is silent for its first two seconds on purpose — set your volume before it starts, and be ready to drop it again.

What it sounds like

These numbers are measured off a recording of the printed part, not predicted from the drawing:

  • a 2205 Hz carrier — right in the band human hearing is most sensitive to

  • partials about 5 dB down at 2145 and 2277 Hz, which is the two chambers pulsing against one another, so the note warbles roughly 70 times a second instead of sitting flat

  • harmonics at 4473 Hz and 6707 Hz

A steady tone is easy to mistake for machinery. A warbling one is not, which is the whole reason a rescue whistle beats shouting.

How it works

Behind the stick is a plenum, and behind that two stopped-pipe chambers of slightly different length sharing one windway, split by a 1.2 mm centre deflector. That is the Fox 40 layout — the architecture the printed whistles that win side-by-side loudness tests all share, and the reason there is no pea. It is the same core as the Narwhistle; the beaver comes out 60 Hz lower.

Every acoustic surface is a vertical wall in the print pose: both 1 mm windway slots, the septum, the chamber walls and the labium edge. That is why it needs no supports and why the edge comes out sharp — a whistle goes silent when its labium prints as a layered overhang.

Printing

Print exactly as exported: tail and feet on the bed, stick straight up. 0.4 mm nozzle, 0.2 mm layers, 3 walls, 15 % infill, supports OFF, a 3–5 mm brim. PLA — the one in the photos is brown.

Put the Z-seam on the belly side — the side with the paws, without the slots. A seam blob inside a 1 mm windway is the one thing that can mute it.

Please read this bit

This is not an indoor toy. It is as loud as the referee whistle it is modelled on, and small children put whistles directly against their own ears. Lanyard hole goes through the tip of the tail.

99 × 26 × 50 mm · one piece · ~16 g at 15 % infill · about 1 h 30.

Tags