Rebirth Insert (NL Remix for ENG fit)

I liked the original NL version of this but it was too tight in my English edition and caused the box to bulge a bit.  Use the player inserts from the original, unchanged.  I made the cards, tower-tile, and corner boxes a little smaller for a cleaner fit in the box (shaved off about 1.6mm).  Also carved some out of the corner for less filament usage.  Finally, added a spacer which is optional, if you want to keep the tile and card boxes from sliding around.

I printed all in PLA at 15% infill, .2mm layer height, 2 wall loops.

From the "Tall Trays" folder, print:

• 1x tower-tiles_remix

• 1x corner_remix

• 1x cards_remix

• 2x spacer [optional]

• 4x player trays from the original

I also made a "short trays" version, where there are hollow spacers that hold up trays, and that use a little bit less filament than the other style.  Instead of the above, you can print the below from the "Short Trays" folder.  You can see what that will look like in the images in the screenshot from Fusion.

• 1x corner_short

• 1x corner_short_spacer

• 1x tower-tiles_short

• 1x tower_tiles_spacer

• 1x cards_remix [in the tall trays folder]

• 4x player trays from the original