Ryobi PCL705 Hand-Vac Wide Nozzle
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
TPU sleeve push-on 100mm wide nozzle for cleaning larger surfaces.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 6
- Makes
- 0
- Views
- 37
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
After vacuuming up a larger area I saw the need for a wider nozzle. This one is 20mm X 100mm and uses a slightly tapered TPU sleeve for a good secure fit on the vacuum cleaner. The main nozzle is PLA and prints with nozzle down on the plate. There are indentations across that nozzle surface for air to be pulled underneath so small strips will print first. My printer auto selected a brim for that fact. After the first few layers print you will see a uniform perimeter, and it should print fine from that point. Supports will be needed. The angle is 10 degrees. Tree supports are best. A row will print up through the nozzle for the inside and one for the ring where the TPU sleeve joins. Assemble by pushing the small end of the sleeve over the nozzle ring. Pull sleeve back until it pops in place. There is an inner ring 3mm up from the small end of the sleeve for keeping the sleeve in place.
The cap is made from Ziro TPU 95A and Sunlu Black PLA, 0.20 layer, 3 to 4 walls, 25% infill