Makeup Palette Racks and 3-Bay Caddy

Overview

Stacked palettes in a drawer mean digging through the whole pile to reach the one at the bottom. This set stores them on edge instead, like books on a shelf, so every palette stays visible and can be pulled out individually. Three separate parts, printable independently depending on what you actually need.

Tight Palette Holder — 6 slots of 22 mm, sized for standard eyeshadow palettes and slim compacts.

Large Palette Holder — 4 slots of 40 mm, for thick palettes, hinged cases, cardboard boxes and anything that will not fit the tight version.

Pot — a 3-compartment caddy with a two-level design: one shallow bay for tubes, compacts and short items, and two deeper bays for pencils, liners and brushes that need more support to stay upright.

Technical specifications

Tight Palette Holder
Footprint : 150 × 125 mm
Height : 43.5 mm
Capacity : 6 slots, 22 mm clear width

Large Palette Holder
Footprint : 172.5 × 125 mm
Height : 43.5 mm
Capacity : 4 slots, 40 mm clear width

Pot
Footprint : 190 × 80 mm
Height : 83 mm (63 mm on the low bay)
Capacity : 3 bays, approx. 61 × 76 mm each

Both racks share the same construction: a 3.5 mm base plate with 2.5 mm dividers standing 40 mm tall over the full 125 mm depth, with rounded top ends on each divider.

The Pot has 2 mm walls and a 3 mm floor. Internal depth is 60 mm on the shallow bay and 80 mm on the two deep bays.

Recommended material: PLA is sufficient for all three parts.