Federal Signal 2T22 Siren (Fully Functional)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a Federal Signal 2T22 Siren. This siren is fully functional and works with 2x small DC motors!
- Rating
- 5 / 5
- Likes
- 7
- Downloads
- 28
- Makes
- 0
- Views
- 237
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
This is a functional 2t22 siren model with Dual Tone! It works with two DC 130 motors. Please excuse me for having two motors and covering them with a motor cover. This is not the case with the original 2t22, but I wanted to design the model so that no special hardware is required and as few parts as possible need to be ordered or organized. The model should not be difficult to print.Actually, I wanted to make a 3T22 WITH solenoid valves, but because of the size of the model, I didn't want to add them.
How to build this siren
Step 1: - Check your Hardware
To Start you need to print out the 3D models:
hat (1X)
top intake (1X)
bottom intake (1X)
top rotor (1X)
top stator (1X)
bottom rotor (1X)
botom stator (1X)
horns (22X)
motor cover (1X)
Stand (Choos one or print both)
Aditionaly check the hardware:
DC 130 Motor (2X) (or other)
Cable (Use 1 meter, if you want to install it 2-3 meters)
Tools:
Glue
Soldering iron
Step 2 - Built it togehter

To assemble this siren, glue one motor to each stator. To do this, apply glue to the motor and the stator and insert the motor shaft through the hole. Next, solder a wire to each motor; it doesn’t need to be long yet. Then, mount the chopper for each corresponding stator—that would be the 10-port and 12-port models.
In the next step, mount each of the two stators—with their respective motors and rotors—to the motor cover. You can either solder the two motors together now or pull them out separately. Next, mount the two intakes. Make sure the 12-port stator and rotor are on top. Then mount the cap on top of the intake.
Now place the whole assembly on the designated stand, but you don’t need to glue it in place yet—you can also wrap some tape around it to hold it in place for now. Now you can glue the horns on completely. Be sure to use strong glue and let it dry long enough. It might fall off again! Now you can either leave the siren as it is, or permanently glue the stand or the mast mount in place. Now the siren is finished!