Makera Z1 Dust shoe
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Version 1 of a dust shoe designed for the Makera Z1
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 31
- Makes
- 0
- Views
- 382
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
For those who like me don't like the mess made by the Makera Z1 while machining, I designed a simple dust shoe that clamps on the spindle to try and ease the mess made by the machine.
The shoe is made of two parts held together by magnets, the hose adapter itself is held in place by other magnets so it can be easily replaced or disconnected.
There aren't many places to clamp the upper part of the dust shoe on so it uses one of the M3 screws on the spindle cover (the one where you fix the ionizer module) and then it clamps on the Z plate and it's held in place by friction.
The upper part of the dust shoe doesn't impede the airflow from the spindle fan, so everything works as before. The second half of the dust shoe has a small recessed rail on the bottom where bristles or a transparent nylon skirt can be glued. All the parts assembled are shorter than the stickout of the spindle collet so no useful space is wasted.
The shoe is designed to be used with a 20mm pipe in mind, you can comfortably route it on the right side under the frame and it won't hinder any movement of the machine, even with the lid closed. Maybe a 25mm one could work too but I am not sure. I used a washing machine drain pipe which has a thin wall and it's lightweight and has soft rubber caps that hold in place nicely on the pipe holders. I have included with the design various adapters to try on but I find that the straight up one is the best.
For the BOM you'll need:
at least 16 10x2.2mm magnets, i used magnets on both sides of everything but you can use a magnet on one side and a steel piece on the other. Be aware of the polarity if you use magnets in pair
2-3mm thick Nylon skirt or bristles, your choice
One M3x25mm TCEI screw plus M3 nut for the rear clamp
four M3x15mm TCEI screws plus M3 nuts for the rear hose adapter
The M3x6mm TCEI screw that comes with the machine for the side
Print recommendations:
Use at least PETG but ABS/ASA would be the best as temperatures may get too high for PLA, 3 or 4 walls with 15% infill are ideal, holes are already slightly oversize to accomodate print tolerances but as usual verify with your printer. Supports are required for most of the curved pipe adapters.
Remix culture is encouraged, I have included a zip with the STEP files of everything so you can adapt it to your tastes or edit the holes to adjust tolerances.
