Virginia opossum Cranium and Mandible
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remixed opossum (Didelphis virginiana) cranium and mandible with high detail
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 25
- Makes
- 0
- Views
- 116
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Chemistry & Biology
- License
- Creative Commons — Attribution — Noncommercial
These models of a Virginia opossum (Didelphis virginiana) cranium and mandible were originally made available on Sketchfab by Oregon State University under CCA license.
My changes to the original model:
The models were very high resolution photogrammetry models, so I decimated them, closed any holes, applied smoothing where needed and thickened areas that were too thin to print.
Print Settings:
0.12 mm layers
3 walls, 10% gyroid infill
tree supports:
20 degrees for the cranium and 35 degrees for the mandible (you can see this difference in the per object settings)
top z distance = 0.2
top interface layers = 2
top interface spacing = 0
tip diameter = 2
I tried the mandible in a couple of different orientations and liked this one better (back on the condyles). The orientations I selected keep all the teeth intact with high detail. Supports are easier to remove with matte PLA. For my photos, I used eSun bone white PLA+ and Sunlu matte bone white PLA.
Note that I am using a cool plate, so you might need to switch the plate in the print profile. I have uploaded a generic 3mf as well as the STL models in the correct printing orientation.
Bambu profile is on Makerworld.
