Modular Dymo 550 Label Roll Rack
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A modular rack for Dymo 550 label rolls, built around the spare spool part from your own Dymo LabelWriter (450/550).
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 6
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Public Domain
About this design
A rack to keep your Dymo 550 label rolls tidy and within reach next to your label printer. Each module is one "slot": you drop in a roll of labels (using the spare spool part you already have for your Dymo), and underneath it there's an open storage bay for extra stock rolls of the same width. No loose parts, no glue, no screws needed to print the rack itself — just the spare spool part you'd normally use in your Dymo anyway.
Designed around the spool part Dymo uses on the LabelWriter 450, 550, 400, 300, and Wireless models (adjustable from roughly 19 to 59mm wide) — no separate pin or axle needed, your spare part already does that job.
How it works
You simply drop the roll (with the spool part on it) into two open notches in the side walls from above. The thin axle on each side of the spool part falls into the notch and spins freely there — exactly like inside the printer itself. Want to swap the roll? Just lift it back out, no parts to unscrew.
Modular & expandable
Each module has:
a male dovetail rail on the right wall, and
a female dovetail channel on the left wall.
You join two modules by holding module A above module B (rail aligned above the open channel) and letting A slide straight down until both bases sit flush — exactly like a camera quick-release plate or a drawer dovetail joint works. So you can print one module today for one roll width, and add more modules later, even in a different label width — the joint itself works independently of the module width.
Wall mounting
The back wall has 2 screw holes (Ø4.5mm) so you can mount the rack to a wall or shelf. Each module has its own holes, so a whole row of joined modules can be mounted the same way.
Adjusting the settings (in OpenSCAD)
Open the .scad file in OpenSCAD (free) to adjust it to your own parts:
LABEL_WIDTH — width of your label roll (common Dymo D1 sizes: 12, 19, 24, 32, 36, 54mm). Print a separate module for each roll width you use.
AXLE_D — diameter of the thin axle on each side of your spare spool part. Measure your own part with calipers for a precise fit — this may vary by part/supplier.
ROLL_MAX_D — outer diameter of a full, new roll (determines the depth of the rack).
WALL_MOUNT — turn the screw holes on/off.
The rest of the dimensions (notch, storage bay, joint) recalculate automatically from these 3 values.
Print settings
Print flat on the bed as designed (base plate down) — no supports needed, the notches are open at the top.
15-20% infill with 3+ shells is plenty strong for lightweight paper rolls.
Material: PLA or PETG, both work fine.
The dovetail joint may feel a bit stiff the first time (layer lines/ tolerances) — a bit of wax or a light sanding pass inside the channel helps it slide smoothly.
What you need
1 print per module (STL, or your own export from the .scad file).
Your own spare Dymo D1 spool part(s) — no extra hardware required.
Optional: 2 screws per module for wall mounting.
