Prusa CORE One INDX Nozzle Seal Holder – Uses Prusa XL Seals – Prusa Edition
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Seal holder for INDX Prusa Edition, adapted to use readily available Prusa XL nozzle seals for easier DIY tool additions
- Rating
- 5 / 5
- Likes
- 21
- Downloads
- 37
- Makes
- 4
- Views
- 490
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Open Community License v1.1
Overview
This remix makes readily available Prusa XL nozzle seals usable with INDX, providing a practical way to source the additional nozzle seals needed when adding DIY tools to a CORE One INDX setup.
Designed specifically for the INDX Prusa Edition, the holder uses the standard Prusa Edition mounting points while adapting readily available Prusa XL nozzle seals for use with additional tools.
Prusa XL nozzle seals use a spring-steel strip that is 5.5 mm shorter than the original INDX strip. The holder geometry compensates for this difference, maintaining the required seal position without modifying the components.
Included Model
A single holder designed specifically for the INDX Prusa Edition front profile and Prusa XL nozzle seal components is included.
Unlike the original Prusa Edition holder, this design keeps the spring-steel strips straight, providing a simpler and cleaner seal arrangement similar to the Founders Edition. The original Prusa Edition design angles the strips to clear the front-profile mounting screws. By repositioning the seal mounting geometry, this holder eliminates that interference while retaining the standard Prusa Edition mounting points.
Compatibility
INDX Prusa Edition
Required Hardware
2× M3×8rT screws to attach the holder to the front profile
2× M3×6rT or 8rT screws to attach the nozzle seal assemblies to the holder
Prusa XL Parking Plate Set
The standard Prusa XL Parking Plate Set provides both the spring-steel strips and silicone seals needed to assemble the nozzle seals for this holder:
Original Prusa XL Parking Plate Set
Print Settings
The following settings were used for the tested print:
Nozzle: 0.4 mm
Layer height: 0.20 mm
Perimeters: 4
Infill: 20% gyroid
Material: PETG
Supports: Not required
These settings produced the tested part and are provided as a reference.
Assembly
Install the Prusa XL nozzle seal into the holder
Position the holder on the front profile
Align the holder with the mounting holes on the INDX Prusa Edition front profile
Secure the holder following the standard INDX installation procedure
Verify that the nozzle seal is correctly positioned against the nozzle
For the complete nozzle seal holder installation procedure, refer to the official Prusa INDX Prusa Edition instructions:
Feedback
If you make this model, feel free to leave a comment or share your feedback. I always enjoy seeing how it fits into different setups and how it performs in real use.
