Squeeze Breeze — Trigger-Spun Fan Toy (no batteries, mechanical novelty)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A no-batteries mechanical novelty: squeeze the finger trigger and a multi-blade propeller on a flywheel spins up…
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 8
- Makes
- 0
- Views
- 113
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution
Squeeze Breeze — Trigger-Spun Fan Toy
A no-batteries mechanical novelty toy: squeeze the finger trigger and a multi-blade propeller on a flywheel spins up through a one-way ratchet, then coasts between squeezes. A genuinely satisfying hand-powered fidget that looks like a little hand fan.
⚠ PLEASE READ — this is a TOY, not a real fan
It does NOT produce a real cooling breeze. The mechanism is fun — the blades really do spin up and keep going — but the airflow you feel is, at best, a faint wisp. Buy it as a mechanical fidget / desk toy / conversation piece, not as a way to cool down at the beach. I'd rather set the right expectation than have you disappointed. (Also note: the optional front grille/cover is left off this release — it fouled the rotor and wouldn't stay seated, so the fan ships open-faced. An open-face cover is on the to-fix list.)
How it works
The trigger carries a sector gear that drives a pinion at 4 : 1.
The pinion turns an external ratchet ring; the rotor's pawls catch it on the squeeze and drive the prop, then click freely past on the spring return (an overrunning clutch) — so every squeeze adds spin in one direction.
A perimeter flywheel stores the momentum so the prop coasts between pumps.
A built-in leaf spring resets the trigger.
Parts (5 printed parts, open-faced)
STL | Qty | Role |
| 1 | Pistol grip + fan-head cage + two posts |
| 1 | Finger lever + 48-tooth sector gear + return leaf spring |
| 1 | 12-tooth pinion fused to the ratchet ring (overrunning clutch) |
| 1 | Two pawls + 7 pitched blades + flywheel rim (pre-flipped for the bed) |
| 1 | Prints two press-in retainer caps (one per post) |

Assembly (no glue, no screws — ~2 minutes)
Step 1 — Trigger onto Post A. Line the sector gear up with the vertical slot in the grip-side cage wall and lower the trigger straight down until it sits flat in the grip. Flick the leaf-spring tip past the body's little reaction post so it pre-loads — the lever should now swing and spring back on its own.

Step 2 — Driver onto Post B (central fan post), pinion-down. It must mesh with the trigger's sector gear — rock the trigger and the driver should turn.

Step 3 — Rotor onto Post B, on top of the driver. Its two pawls land around the ratchet ring. Check the clutch: turn one way it catches, the other way it clicks freely.

Step 4 — Press a cap into each post (stem-down). The caps trap the spinning parts so they can't lift off but still spin. That's it — squeeze and it spins.

Print notes
0.2 mm layers, no supports, every part prints flat.
PETG recommended for the trigger (the leaf spring is cycled); PLA fine for the rest.
Assembled ≈ 87 × 179 × 42 mm.
Designed from scratch in parametric OpenSCAD (no AI-generated geometry) — tweak the gear ratio, blade pitch, flywheel mass, and spring to taste. The .scad source is attached.
