SawStop Zero Clearance Insert
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Insert for SawStop saws that use 10" blades. Version for both standard 10" blade (TSI-SLD) and dado stacks (TSI-DLD)
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 34
- Makes
- 0
- Views
- 131
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
Description
I based this model on two major sources: an official SawStop Zero Clearance (TSI-SLD) that I already had in my saw, and a model by LXVII for routing inserts, plus spot-checking against a few other sources.
There are four versions:
Standard Blade with Holes
Standard Blade without Holes
Dado with Holes
Dado without Holes
All versions have a print-in-place locking handle included.
The versions "with holes" have the same 6 threaded holes for leveling/locating that the official SawStop one has. They will accept M6 Leveling Insert Screws (CB104 010) and M6 Set Scew (CB104 078), which are used to level and center the plate. These versions have the same 13mm overall thickness as the official version to allow the leveling screws to work.
The versions "without holes" have slots that should line up with the Leveling Insert Screws found on the saw itself to hold the position of the insert. These versions have a 15.5mm overall thickness which should be very close to the proper height without any leveling.
I have also uploaded the Fusion files to allow for any editing if people find small adjustments are needed for their specific saws. I have done my best to make it easy to see what is what by naming everything. Unfortunately, there is something odd going on where some configurations don't rebuild properly, but fixing them should be fairly easy — it mainly requires picking the main body as the target of one combine function and one split function.
Assembly
The dovetails are designed with a small draft angle for a tight fit, so they can only be inserted from one direction. They should go about 75% of the way in with very little force, but the final seating might take some small taps with something heavy. If they are really not fitting than the Fusion file has a dovetail offset variable that can be changed.
Printing Tips
Importing Files
All the files are uploaded as 3MFs with all parts together. I recommend separating the major parts, but keep the handle attached to the main body. I believe the parts should fit on printers with build plates that are 220mm or larger. It also imports the part with the wrong Z orientation, so make sure to print on the (mostly) smooth side.
Handle
The handle should print in place without any specific settings, but does benefit from a single point of support at the tip of the overhang:

Dado Infill
For the "Dado" versions, I recommend printing with 100% infill in the areas where the blade will penetrate the insert. The photos below show the settings and placement I used, but it is basically where the "arbor scoop" is located.


