Basic Sunshade for Ronin 4D
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple sunshade for the Ronin 4D. Not perfect, but does a decent job of reducing glare.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 22
- Makes
- 0
- Views
- 108
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a basic/simple sunshade for the monitor that is included with the Ronin 4D. It's far from perfect, but it does a decent job of reducing glare on the monitor when outside. There are cutouts to ensure that all of the buttons/dial are reachable. This has been designed only for use with the connector attached to the side, it will not work with it attached to the bottom of the screen.
Because of the cutouts, it's possible for a little bit of light to leak through the edges - I chose this vs tightening down the cutouts and making it harder to press the buttons.
You will need to supply two short M4 screws to attach it to the bottom mounting holes for the handle.
To get rid of rattle/flapping due to the connection points only being at the bottom of the screen, I use a small strip of velcro near the top rear of the screen.
This is my first version - it's a little bit too short so I'll upload another version soon which will add about an inch to an inch and a half to the shade.
When I print, I do supports on the build plate only which will add some small supports underneath the dial cutout.