Corpse Bride

PLEASE READ THE DETAILS!!!!!!!!!!!!!!!!!!!!!!!!!! VERY IMPORTANT FOR VICTOR OR HE WILL FAIL!!!!!!!!!!!!!

This is a 3-D model of the corpse bride movie. You have Emily and Victor standing on a base that represents them.

When it comes to Victor, he is a little bit of a problem to print

Since he is very slender and long when you go to print him, you want to do five walls

You also want to do at least 15% infill gyroid

I did print him at .08 layer height

He does stand about 300 mm tall

Emily also stands about 300 mm tall they are 1/6 scale

The base should fit just fine as it's not very wide

This is dependent on your printer and your bill plate volume. The base is about 244 mm wide.

When it comes to these characters, I could not make cuts on them due to their slender builds since his legs are so thin he's very susceptible to breaking and that is the reason for the five walls

Please note you also want to make sure that you do branch style supports. I would recommend putting a brim down and I would also recommend expanding that first layer adhesion of the supports to about 8 mm.

You should see a decent size trunk that is going to come up on the sides of Victor, which will help protect his legs from being broken

As another note, I do want to make sure that you have the hop turned on and you want it at .4 mm

As I mentioned, I printed Victor at .08 layer height and he took about a day to print

For Emily, I did the adaptive layer height, and I made sure that her skin portion from the top up so her chest to her head was at 8.08 layer height, the adaptive layer height, which did bigger layers in her gown. Her torso was perfect. It helped the print time and she got done in about a day as well. Otherwise, it would've took at least two.

Victor used about 175 g

Only used about 465

And the base will use roughly 700g if you do 5 to 8% in fill and .16 or .18 layer height