Pi Case for Arducam HDMI Adapter With Fan (30mm or 40mm)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a case for a Rasberry 3B+ and is a remix of "Raspberry Pi 3 B+ Ultimate Cooling Case" by Pablofette" This case…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 8
- Makes
- 0
- Views
- 210
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
This is a case for a Rasberry 3B+ and is a remix of "Raspberry Pi 3 B+ Ultimate Cooling Case" by Pablofette" This case is designed to hold an HDMI adapter, a fan and a on-off switch for the Pi.
This Pi case is made to fit with an Arducam CSI to HDMI adapter that can be found on Amazon. It's used in conjunction with the HDMI camera mount https://www.thingiverse.com/thing:3421954.
What this does is eliminate the ribbon cable going to the camera and instead uses an HDMI cable, so if needed you can have a longer cable. It's also neater and much more robust than a ribbon cable. You will need a low profile HDMI cable either with or without a flat 90 degree end.
This case also has provision for a 30mm or a 40mm fan. I put a 30mm fan in mine because I found it with the pins for the GPIO connector.
I also put a 10mm hole in the side of the case for a on-off switch.
To mount the Arducam adapter you will need some very small screws, I don't know the size as I got mine from another electronic project. Maybe M1 or M1.5.
To mount the Pi I drilled out the mounting holes and used screws. The original thing used printed pins which I have included the STL file.
The screws for the case I used M3 x 25mm.
Category: 3D Printer Accessories