1 / 2
Makera Z1 compact dust shoe — image 1
1 / 2

Makera Z1 compact dust shoe

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Dust shoe V2 - compact magnetless version

Rating
5 / 5
Likes
17
Downloads
56
Makes
1
Views
420
Reviews
2

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution

Edit 25/09/2026: added both stl and step files for the rear pipe holder

Here's another dust shoe for the makera Z1.

As I am unable to use the machine due to having all my lab upside down due to slowly moving house, I keep designing things to help future me having a less messy machine. 

This time I designed this dust shoe to be as compact and material-efficient as possible, also the main objective was to avoid magnets entirely. As I plan on milling soft stones (soapstone-like) in the future, I designed this more compact version to help extracting as much dust as possible.

This time the chips/dust should be more in line with the extraction path, so technically extraction should be better even with lower powered vacuums. 

It's made in three pieces: the main dust shoe, the flange and the 20mm straight fitting. The flange bolts on right on the side where the ionizer module sits, the shoe and the fitting are then glued in place in the main flange. I purposely left the tolerances a little on the high side to help better position the shoe, be sure to adjust it when it's free before gluing everything. You can reduce the main body inner diameter by 0.1mm to have a tight press fit (always check and know beforehand your printer printing tolerances). 

9 Holes are provided to screw your choice of skirt, I always recommend a soft PU sheet so you can always see your work and (anecdotal) provides a somewhat better seal. Just cut to lenght, punch the holes in the material with something pointy (i used a modeling hand drill with an 2.4mm bit) and you're set. With longer screws I think that a bristle strip can be used. Normal hex screws can self tap the hole and hold in place the skirt, but nuts can be used on the inside if needed.

As usual, STEP files are included and remix culture is encouraged, adapt it to your tastes or make it even better!

BOM:

  • 9x M3x5mm HEX screws

  • A 0.8-1mm PU sheet  

Print recommendations: 

  • 3 Walls

  • 15% infill

  • PETG recommended, ABS/ASA always better.

  • Print the flange on the small flat side to have a better round hole

  • Print the fitting on the bigger side, prints well without skirts if you trust your bed adhesion

Tags