1 / 1
Jonsbo N6 Noise Reduction Feet
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Feet you can print out of TPU to reduce HDD noise transfer to surfaces
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 6
- Makes
- 0
- Views
- 45
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution
Replacement feet for the Jonsbo N6 NAS case that help reduce noise transfer.
I printed in 95a TPU, 2 walls, 5 top/bottom, 10% cross hatch and they a good consistency for my setup (6 HDDs populated). I would recommend a 1mm bottom surface (5 layers at 0.2mm) so that the area under the bolt is fully solid.
4 of them at those print settings used about 27g of filament and 1:20 to print.
These are 40mm x 17mm (wxh), stock is about 38x12 so they will take up slightly more space.
Remove feet, reuse screws, install new feet.