Hinge WH-1000XM4 FIX
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
this is a fix for the hinge problem on the WH-1000XM4, not the internal one, but the outside fix, ugly and practical
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 2
- Makes
- 0
- Views
- 43
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Music
- License
- Creative Commons — Attribution
this is a fix for the hinge problem on the WH-1000XM4, not the internal one, but the outside fix, ugly and practical
i do advise you to use the M3 Insert route, i did the zip tie route, but i didn't think it fixed as much as slipped at times, i did add the .Step file if you want to change anything on the file.
the M3 insert can be used up to 8mm, but i used a 4mm high one, you could theoretically use a m3x16. but i advise you to use a m3x20, i designed for SHCS, but it probably work with any type of head.
the M3x20 i prefer because when you put you need to have some leeway to it doesn't skip before you really screw it in.
edit: 09/24/2026: as luck may have it a a day later the other side broke too, i didn't want to print another piece, so i tried using one of the early designs with a zip tie, and sincerely it does not work, i will keep the design in there as there is some modification but i would not rely on it.
go for the M3 route.
also be mindful that both sides are not equal, if you print as is, the top side is slightly bigger to compensate for the larger size of the casing on that side. and this should be the one pointed down.
at a point that if you see on my newest picture with both sides fixed, each side has the screw head pointed inverted as i needed to have the bigger size pointed down.
also i printed on 0.4 nozzle and 0.2 layer height AND 0.6 nozzle and 0.3 layer height. so both configurations work.
i hope it helps someone.
Edit: 10/28/2026, after one of the sides failing i decided to restart from zero and it was a waste of time, i could not properly fix again, i went back to this specific design that was good, but for some reason was not securing properly. what i did was making the space even higher, so the screw would have more space to screw in, i recommend you you use a insert, or at least a m3 nut. it needs to clamp hard. i recommend at least a 25mm screw on the side that is larger, and a 20mm on the side that is smaller, you can do with a 20mm on the larger side, but you will suffer more than necessarily. when putting the screw start with the larger side or the ear part. push it down as much as you can put the screw and screw it in until you few it's firm, then screw the other part. then screw the ear again.
and it should work, good luck.