Warthog front GPU airflow scoop
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This prints directs air from the front fans up towards the GPU and have room under it for cables.
- Rating
- 0 / 5
- Likes
- 12
- Downloads
- 94
- Makes
- 0
- Views
- 772
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution
A comment was brought up by Gamers Nexus about how the front of this case could use an airflow scoop, so here is one that fits perfectly and leaves a little room under it to hide cables if needed.
This scoop still allows for fans up to 31mm in thickness to be mounted to the side fan bracket.
Print in this position with supports under the left lip - the rest of the part can print without support. Brim might be needed depending on your bed adhesion.
Print settings:
PETG or PLA will work just fine. We recommend using adaptive layer height since the front has a very steep angle and could benefit from low layer height.
Push the scoop into place so it "clicks" into the PSU shroud and then secure it with two standard UNC 6-32 screws (the case will come with extra).