1 / 3
Keebio Iris PE mechanical keyboard case — image 1
1 / 3

Keebio Iris PE mechanical keyboard case

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Top plate and tented (10.6 degree) middle layer for a Keebio Iris PE mechanical keyboard.

Rating
0 / 5
Likes
0
Downloads
1
Makes
0
Views
23
Reviews
0

Updated at source:

Model information

Category
Computers
License
Creative Commons — Attribution — Noncommercial — Share Alike

Printing

Top plate

Orient on build plate with top down.

  • Filament: PLA

  • Walls: 4

  • Infill: 100%

  • Layer height: 0.2mm

  • Supports: No

Middle layer

Orient on build plate with top down.

  • Filament: PETG recommended due to thin walls. Transparent PETG will allow light through.

  • Walls: 2

  • Infill: 8%

  • Layer height: 0.2mm

  • Supports: No

Bottom plate (optional)

The middle layer walls are thin, so to make the keyboard sturdier (eg. for transport), you can add a bottom plate.

  • Filament: PLA

  • Walls: 3

  • Infill: 20-50%

  • Layer height: 0.2mm

  • Supports: No

Assembly

Hardware required

  • Switches & keycaps

  • Iris PE PCB

  • Rubber feet

Option 1: For top and middle only
  • (20) M2 x 6mm screws

  • (20) M2 heat set inserts (I used brass standoffs)

Option 2: For top, middle, and bottom
  • (40) M2 x 6mm screws

  • (40) M2 heat set inserts

Top plate

  1. Deburr top of each switch hole before trying to insert the switches.

  2. Check that holes in top plate are big enough for M2 screws. You may have to enlarge holes slightly using a soldering iron or drill.

  3. Insert all switches through top plate into PCB as instructed at https://docs.keeb.io/iris-rev6-build-guide

Middle layer

  1. Insert M2 heat set inserts flush with top using soldering iron.

  2. Line up top plate with middle plate and screw in all screws.

  3. (optional) If you are using a bottom plate, insert M2 heat set inserts flush with bottom and screw in bottom plate.

  4. Add rubber feet to bottom.

Tags