Sleeve/Grip/Shealth/Second Skin/Exoskeleton for Lenovo Pro Pen (ThinkPad YOGA L380/390 X380/390
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Lets you hold the tiny pen better
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 5
- Makes
- 0
- Views
- 36
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Share Alike
An ergonomic improvement for Lenovo Pro Pen from Lenovo ThinkPad YOGA L380, L390, X380 and X390 models and maybe some others. Tested on L390 model specifically.
Does not fit within Apple Pencil dimensions and is not compatible with its accessories. I've considered it at first, but charging part heavily restricts it.
Not compatible with Lenovo Active Pen 1/2 and their accessories. Therefore does not fit in its USB holder. Will make one later.
Consists of two interlocking parts. Must be taken out each time for charging. Not pretty, but you have to sacrifice something.
Buttons do work, but it's not great to use - they're too high, and transfering presses through the plastic degrades experience considerably.
Fits with factory sticker being intact, but you should be careful putting the pen in - I damaged sticker on mine during prototyping and had to remove it.
PETG/PLA etc. Don't use brittle polymers or resin, model requires flex to fit properly.
Sparce infill density - whatever, depends on whether you want to have a counterweight on part B. I used 15% Gyroid pattern. You may increase it up to 100%, but it will significantly increase printing time and may introduce printing/warping issues. You can use less quirky patterns without any issues.
Concentric pattern on bottom surface and internal solid infill, for better speeds.
Use Monolithic or Monolithic Line on top surface instead of concentric, will look ugly otherwise.
Use (nail) file to file / knife to cut down interlocking parts a tiny bit if doesn't interlock at first.