MX Dual Wield DARTH MxAUL 200% Keyboard
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Both keyboards connected and using only half of each creates a pretty decent split keyboard setup.
- Rating
- 5 / 5
- Likes
- 19
- Downloads
- 3
- Makes
- 0
- Views
- 220
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution
VERY IMPORTANT *
Behold! The Darth MxAul adapter and separate legs for dual weilding 2 MS Keys S. Both keyboards connected at the same time allows you to use half of each keyboard hands aprox shoulder width apart, and typing speed appears uneffected (capacity of boards, not of user, user will definitely be effected).
*THIS MODEL IS PRINTED WITH THE HEIGHT DIMENSION (AS IT SITS ON A DESKTOP) ADJUSTED TO 103%. IT IS TO TIGHT WITHOUT IT. (the little rubber feet should be peeled off before shenanigans and stuck back on after, where the center piece is, other wise it'll be to hard to remove).
Probably just don't print this even though it is solid as a brick with no flex is very fun to type on and can turn some choice seating into absolute battle stations!
If you must print one refer again to the *. It requires supports and should be printed on standard settings and standing up so the z dimension is the length. so for example if printing on a bambu slicer < Lay on edge (make it stand up) < Scale < unclick "uniform scale" < adjust x dimension to be 103.
The longest dimension is 247mm