Twisted Hex Vase for LEGO Botanicals Daisies (11508)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A twisted hexagon bud vase sized for the LEGO Botanicals Daisies set (11508). No supports, no brim.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 15
- Makes
- 0
- Views
- 58
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Creative Commons — Attribution — Noncommercial
A low-poly hexagon vase with a 90° twist, designed to display the LEGO® Botanicals Daisies set (11508). The box says "vase not included", so here's one.
Size: 110 mm tall, 84 mm across at the widest point, with a neck opening of about 28 mm. It takes the whole Daisies set with room to fan the stems out.
Files
daisy-vase.stl (recommended): 0.85 mm walls, exactly two lines with a 0.4 mm nozzle. It prints as clean continuous loops with no zig-zag gap fill in the walls.
daisy-vase-thick-walls.stl: the version in the photo. 2.4 mm walls, so it's heavier and stiffer but slower, and the slicer adds some gap fill inside the walls.
daisy_vase.scad: OpenSCAD source. You can change the height, twist, width and wall thickness.
Print settings
These are the settings I use on a Flashforge Adventurer 5M Pro with a 0.4 mm nozzle in Flash Studio. OrcaSlicer, Bambu Studio and PrusaSlicer have equivalent settings.
Material: PLA. The photo shows a dark "galaxy" sparkle PLA, which hides layer lines well on the twisted faces.
Layer height: 0.2 mm
Wall loops: 2 (use 6 for the thick-walls file)
Wall generator: Arachne. This matters: Classic can't fit the slightly thicker hex corners and fills them with zig-zags on every layer.
Ensure vertical shell thickness: None. On sloped, twisted walls the default adds patches of solid infill that make the head go back and forth.
Seam position: Aligned. The seam tucks into a hex corner and follows it up the twist.
Top/bottom shells: 5 bottom layers
Infill: 15% gyroid (it's only used in the floor)
Supports / brim: none. Print it standing on its base. All overhangs are gentle.
With these settings, everything above the floor is just the two wall lines, so the head goes smoothly around the shape on every layer.
Tips
The bouquet is taller than the vase and a bit top-heavy, so pour a handful of rice or aquarium gravel into the base before adding the flowers.
It's designed for LEGO flowers, not water. It hasn't been tested as watertight.
There's a larger version for the LEGO Botanicals Flower Bouquet (10280) on my profile.
LEGO® is a trademark of the LEGO Group, which does not sponsor, authorise or endorse this model.