MPC One G2 Stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a stand for the MPC One G2 that raises it to the height of typical DJ equipment and mixers.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 33
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Music
- License
- Creative Commons — Attribution — Noncommercial
This is a stand for the MPC One G2 that raises it to the height of typical DJ equipment and mixers.
3MF Notes:
The base file uses ABS. However, any filament should work fine, as this part is unlikely to experience extreme heat or prolonged UV exposure.
The Joiners with legs are print in place with specific supports. If printing these without using the 3MF, it is important to not utilize auto supports in your slicer unless you are utilizing a different interface material.
The MPC One Stand Food 3MF/STL is only needed if you will be printing feet out of TPU. 85A or softer is recommended.
Assembly:
Insert the joiners into the stands. The clip goes into the wider portion of the opening.
Attach 3.5mm or 4mm rubber feet to the recesses on the bottom of the stands using your preferred plastic-compatible adhesive.
Use the feet of your MPC to position it securely on the stand.
Jam!
Known Compatible Models:
Akai MPC One G2
Version History:
V1.0 - 2026-09-27 - Initial release. Stand printed and test fitted with an Akai MPC One G2.
V1.1 - 2026-09-28 - Adjusts support settings for clips on Joiners. Added print in place footed joiner file.